![]() |
![]() |
|||
|
||||
|
|||||||
| Register | Forum Rules | FAQ | Search | Today's Posts | Mark Forums Read |
| Welcome Guest Visitor! Please Register, It's Free and Fun To Participate! | |
|
The EXTREME Overclocking Forums are a place for people to learn how to overclock and tweak their PC's components like the CPU, memory (RAM), or video card in order to gain the maximum performance out of their system. There are lots of discussions about new processors, graphics cards, cooling products, power supplies, cases, and so much more!
You are currently viewing our boards as a "guest" which gives you limited access to view most discussions. You need to register before you can post: click the register link to proceed. Before you register, please read the forum rules. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload your own pictures, and access many other special features. Registration is fast, simple, and absolutely free! To start viewing messages, select the forum that you want to visit from the selection below. After you have registered and read the forum rules, you can check out the FAQ for more information on using the forum. We hope you enjoy your stay here! Note To Spammers: We do not allow unsolicited advertising! Spam is usually reported & deleted within minutes of it being posted, so don't waste your time (or ours)! |
|
| Please Register to Post a Reply |
|
|
Thread Tools |
|
|
#21 | ||||
|
The doctor is in...
Senior Member
|
|
||||
|
|
|
|
#22 | ||||
|
Banned
Don't ask why unless you want to join them. |
Cool, cool. Let me get my vga cable back from a friend so I can actually use my server, and I'll get back on some benchies. The rig runs at stock freq, everywhere, so I dont expect it to be fast.
|
||||
|
|
|
|
#23 | ||||
|
Banned
Don't ask why unless you want to join them. |
Sorry for no word on my server rig here in awhile. I just got it to post on 4GB of RAM, so I'm using all of it now! Win Server 2003 pulling it up as 3.74GB tho. CPU-Z has confirmed all 4GB, AND full speed 133Mhz! w00t! No decreased FSB because of mem config. I will be putting server thru benchmarks, and posting here in a little bit.
Additional Comment: BTW, server was down so long because the PSU was acting up. Got new PSU yesterday, 3 hours converting the guts over to the server's native PSU case, and voila! Up and running smooth... I'm getting scary bad benchmarks in SuperPi... Ugh... Additional Comment: I don't know, but something seems BAD about this mobo... This rig's response time is really slow, and for two athlon mp 2100's, the SuperPi's are bad... Scared to even post them... Last edited by swishamane : 04-26-2009 at 05:20 PM. Reason: Automerged Doublepost |
||||
|
|
|
|
#24 | ||||
|
Chief Engineer
Senior Member
|
Put up some CPU-Z tabs and a couple test benchies. I'd like to check it out.
|
||||
|
|
|
|
#25 | ||||
|
Banned
Don't ask why unless you want to join them. |
Aight, just re-ran all the tests.
|
||||
|
|
|
|
#26 | ||||
|
Chief Engineer
Senior Member
|
Did you disable ECC? If you didn't that'll slow everything right down. You could also try to tighten the ram timings a little, if they'll allow it. See if they'll do a CAS of 2.
|
||||
|
|
|
|
#27 | ||||
|
Banned
Don't ask why unless you want to join them. |
Yes, ECC was disabled. This mobo does not give me many options for anything. I can't just adjust timings and voltages, etc... Not sure of any FSB progs that I can use either...
Additional Comment: I noticed the hardware monitor in the bios is reading my CPU's at 1.79v each! WHA!? Could that be accurate? There's PLENTY of air flow with 3 120mm fans blowing across the mobo at all times, but 1.8V! Last edited by swishamane : 05-07-2009 at 10:22 AM. Reason: Automerged Doublepost |
||||
|
|
|
|
#28 | ||||
|
Son of Sanguinius
Senior Member
|
That's correct. Old CPU's run at much higher voltages than modern ones.
|
||||
|
|
|
|
| Please Register to Post a Reply |
| Thread Tools | |
|
|